MINOLTA-QMS Magicolor 2200 Series Manual page 96

2. Remove the fusing fan motor
3. Remove the toner (suction) fan motor
4. Remove the ozone fan motor
2. Remove the left-rear cover.
3. Remove the right-rear cover 1.
4. Remove the right-rear cover 2.
5. Remove the PU1 holding plate (do not remove PU1 from bracket).
6. Remove the 1 connector for the power supply fan and the 2 set
screws. (There are 5 harness clamps.)
1. Remove the rear cover.
2. Remove the left-rear cover.
3. Remove the right-rear cover 1.
4. Remove the right-rear cover 2.
5. Remove the PU1 holding plate (do not remove PU1 from bracket).
6. Remove the 1 connector for the fusing fan and the 2 set screws.
(There are 4 harness clamps.)
1. Remove the rear cover.
2. Remove the left-rear cover.
3. Remove the right-rear cover 1.
4. Remove the right-rear cover 2.
5. Remove the PU1 holding plate (do not remove PU1 from bracket).
6. Remove the 1 connector for the toner suction fan and the 2 stop
screws. (There are 4 harness clamps.)
1. Remove the rear cover.
2. Remove the left-rear cover.
3. Remove the right-rear cover 1.
4. Remove the right-rear cover 2.
5. Remove the PWB-A holding plate (do not remove PWB-A from
bracket).
6. Remove the 1 connector for the ozone fan and the 2 set screws.
(There are 2 harness clamps under the PWB-A.)
7. Remove the 2 set screws for the ozone fan mounting platform.
D-12