Initial Inspection - MINOLTA-QMS Magicolor 2200 Series Manual

1-2 Initial inspection

Item
1. Power supply on
2. Check the power being
supplied to the printer.
3. Check the installation
environment.
4. Check the paper type.
5. Check the maintenance
procedures.
Print a consumable sta-
tistics page.
6. Precautions during
cold weather opera-
tion.
Clean the laser lens cover and paper take-up rollers by gently wiping the surface with a soft, dry lint-free cloth.
Description and cause
1. The engine does not properly oper-
ate no matter how long you wait.
2. Does the engine cooling fan oper-
ate?
(Does it operate when the power
supply is turned on?)
1. Is the voltage of the power supply
within ± 10% of the rated value?
1. Is the area subject to vibration or on
an incline?
2. Is the temperature and/or humidity
within the range presented in Sec-
tion A, "Installation Environment"?
3. Is the area subject to direct sun-
light?
4. Is there a lot of dust or foreign
material in the air?
5. Are there corrosive gases (such as
ammonia) in the air?
1. Is the correct type and size of paper
being used?
1. Has maintenance been properly per-
formed?
2. Is the fusing belt dirty?
If a cold printer is suddenly heated,
condensation can form inside of it and
cause the following problems.
• The lens can become fogged and
make the printed image light.
• The charge may be defective and
make the printed image dark.
• The paper may become damp and
wrinkle or cause uneven printing.
E-3
Corrective action
• Make sure the power supply cord is prop-
erly plugged into the printer and the out-
let.
• Check for a blown fuse on the power
supply circuit board for the engine.
• Check for an engine error and refer to the
proper repair procedure.
Refer to page B-22
Use an outlet with a voltage meeting the
specification standards.
Ensure the printer is level and not subject to
vibration.
Move the printer to a location away from
sources of heat and not in direct contact with
air flow from an air conditioner.
If unavoidable, use curtains or other mea-
sures to protect the printer from direct sun-
light.
Move the printer to a location not exposed to
high levels of dust or other airborne materi-
als.
Move the printer to a location not exposed to
corrosive gases.
Use the type and size of paper recommended
by the specifications for the printer.
Clean the paper transport passages. If the
surface of a roller is noticeably dirty, clean
or replace it.
Replace the oil coating roller.
Turn the power on and allow the printer to
stand unoperated for 20 minutes or more.