3. Remove the registration roller
4. Remove the lower paper take-up guide
Lower paper take-up
guide plate
5. Remove the timing sensor
Timing sensor
6. Remove the OHP sensor
1. Remove the front cover.
2. Remove the control panel cover.
3. Remove the front center cover.
4. Remove the rear cover.
5. Remove one plastic c-clip and the brushing bushing from the front
side.
6. Remove one metal c-clip and gear from the rear side of the registra-
tion roller.
7. Remove one plastic c-clip and the brass bushing from the rear side
of the registration roller.
8. Remove one c-clip and brass bushing from the front end of the reg-
istration roller.
9. Remove the registration roller cover attached to the registration
roller.
10. Remove the registration roller.
1. Remove the front cover.
2. Remove the control panel cover.
3. Remove the front center cover.
4. Remove the rear cover.
5. Remove the registration roller.
6. Lift up the bottom end of the lower paper take-up guide and remove
it from the clamping of the timing roller section.
(b, c sections) (There are 2 connectors.)
1. Remove the front cover.
2. Remove the control panel cover.
3. Remove the front center cover.
4. Remove the rear cover.
5. Remove the registration roller.
6. Remove the lower paper take-up guide.
7. Remove the timing sensor and the 1 connector.
1. Remove the front cover.
2. Remove the control panel cover.
3. Remove the front center cover.
4. Remove the rear cover.
5. Remove the registration roller.
6. Remove the lower paper take-up guide.
7. Remove the OHP sensor and the 1 connector.
OHP Sensor
D-16