MINOLTA-QMS Magicolor 2200 Series Manual page 152

Image defect
Uneven color density
Whited out area
ABCDE
ABCDE
ABCDE
ABCDE
Lateral lines
ABCDE
ABCDE
ABCDE
ABCDE
Image Defects that are Cyclical
(evenly spaced)
ABCDE
ABCDE
ABCDE
ABCDE
Cause
Defective contact at image transfer
roller unit contact point.
If it occurs on one side only, T/C
mounting is loose.
Damp paper.
When whited out.
When using a duplex unit.
1–2 mm spacing.
35 mm developing spacing uneven-
ness.
75 mm image transfer roller.
95 mm OPC drum.
204 mm fusing belt.
Other spacing.
1–2 mm spacing.
35 mm developing spacing uneven-
ness.
75 mm image transfer roller.
95 mm OPC drum.
204 mm fusing belt.
Other spacing.
Same place on page.
E-38
Step
Reset the image transfer roller unit.
Replace the image transfer roller unit.
Reset the toner cartridge.
Replace the toner cartridge.
Adjust the humidity for paper storage.
Use dry paper.
Replace the fusing unit.
Replace the duplex unit.
Replace the laser unit.
Replace the color toner cartridge.
Replace the image transfer roller unit.
Replace OPC drum.
Replace the fusing unit.
Replace the OPC drum.
Replace the laser unit.
Replace the color toner cartridge.
Replace the image transfer roller unit.
Replace the OPC drum.
Replace the fusing unit
Replace the OPC drum.
Replace the image transfer belt.