MINOLTA-QMS Magicolor 2200 Series Manual page 105

2. Remove the left frame plate
3. Remove the belt cleaner release position sensor
4. Remove the PWB-1 (belt cleaner controller circuit board)
1. Remove the 4 set screws for the left frame plate.
2. Remove the 4 connectors.
1. Remove the rear cover.
2. Remove the left-rear cover.
3. Remove the right-rear 1 cover.
4. Remove the right-rear 2 cover.
5. Remove the top cover.
6. Remove the upper-right reinforcement plate.
7. Remove the left frame plate.
8. Remove the tabs for the belt cleaner release position sensor.
(There is 1 connector.)
1. Remove the rear cover.
2. Remove the left-rear cover.
3. Remove the right-rear 1 cover.
4. Remove the right-rear 2 cover.
5. Remove the top cover.
6. Remove the upper-right reinforcement plate.
7. Remove the left frame plate.
8. Remove the PWB-1 (belt cleaner controller circuit board).
(There are 2 connectors and 4 screws.)
PWB-1
D-21