Timing Roller - MINOLTA-QMS Magicolor 2200 Series Manual

1-5 Timing roller

The timing roller corrects the angular movement of the paper that has been sent from the paper take-up section and
adjusts the timing so that the end position of the visible image on the image transfer belt is the same as the edge of the
paper. The timing roller rotates when the timing roller solenoid (SL5) is set on.
• When the timing roller paper sensor (PC5) detects the edge of the paper that has been transported from the paper take-
up has reached the timing roller, the transport roller solenoid is set on and transport of the paper is temporarily stopped
by the timing roller.
• Only during color printing, if the timing sensor is not set on within a specified time after the paper take-up solenoid
(SL 8) has been set on, the paper take-up is performed again to prevent a paper take-up miss.
• The timing sensor detects the length of the paper at the same time it detects the edge of the paper. If the paper is longer
or shorter than the specified length, a paper size error is detected.
Main unit – Rear view
Timing roller solenoid (SL5)
Transport roller solenoid (SL4)
Timing roller paper sensor (PC5)
C-6