Removing The Exterior Covers; Disassembly Procedures - MINOLTA-QMS Magicolor 2200 Series Manual

3

Disassembly procedures

Before disassembling the printer, it may be necessary to remove some of the removable optional or provided compo-
nents (such as the YMCK toner cartridges and OPC drum).
• Never remove the laser lens cover as it prevents toner and dust from falling into the laser unit window during the
servicing.

3-1 Removing the exterior covers

1. Remove the front cover
2. Remove the control panel
3. Remove the front center cover
Toner cartridge
removal lever
í‹
Rack turning knob
(Different Screw)
1. Open the front cover.
2. Remove the mounting screw for the front cover. (1 screw)
3. Push on the right pin section and, while carefully bending the front
cover, remove it to the right.
1. Open the front cover and remove the toner waste container.
2. Remove the 3 mounting screws for the control panel.
3. Open the fusing cover and remove the 1 mounting screw.
4. Remove the mail bin cover (front).
5. Lift up on the control panel, disconnect one connection, and
remove it.
1. Remove the 1 mounting screw for the rack turning knob and
Image transfer
remove the turning knob.
roller release
2. Remove the 2 mounting screws for the image transfer release lever
lever
and remove the lever.
3. Remove the 3 mounting screws for the front center cover. Rotate
the transfer belt handle to remove 1 of the mounting screws.
4. Grab the handle on the right end of the front center cover and pull
towards you. Remove the tabs on the left side, pull on the toner car-
tridge removal lever, and remove the front center cover.
D-7