Test Prints - MINOLTA-QMS Magicolor 2200 Series Manual

2

Test prints

2-1 Engine test print
The following mode is available as a self-diagnostic function.
• Engine test print
To check for problems with either the controller or engine sections.
• The test cannot be performed if there is a displayed error.
Precautions
Do not feed the paper if the display indicates an error.
It takes approximately one minute from the start of the test until the passage of the paper is
completed.
Procedure
1. Turn the power off.
2. Remove the controller.
3. Install one of the following trays: multipurpose tray, upper tray, or lower tray (optional) with paper.
4. Turn the power on.
5. The test will run until paper is consumed, printer turned off, or paper jam occurs.
*Pull out the paper tray to stop the test print operation.
If a duplex unit or 5-bin mailbin is installed, they will automatically be tested for proper operation.
6. If the test print is normal, there are no problems with the engine, which leads to the controller and inter-
face as probable causes for errors.
Test pattern
E-5