Laser Safety; International Notices; Warranty Considerations - MINOLTA-QMS magicolor 3100 Installation Manual

Laser Safety

This printer is certified as a Class 1 laser product under the U.S. Department
of Health and Human Services (DHHS) Radiation Performance Standard
according to the Radiation Control for Health and Safety Act of 1968. This
means that the printer does not produce hazardous laser radiation.
Since radiation emitted inside the printer is completely confined within protec-
tive housings and external covers, the laser beam cannot escape from the
machine during any phase of user operation.

International Notices

Power Cord
The following power cord requirements are in effect for your 220 V printer.
Minimum
Minimum
The male plug is certified in the country in which the equipment is to be
installed, and the female plug is an IEC 320 connector.
Voltage
Attention Norwegian users: This equipment is designed to operate within
an IT power system where the line-to-line voltage does not exceed 240 V.
Lithium Batteries
Attention Swiss users: Lithium batteries need to be disposed of in
accordance with Annex 4.1 of SR814.013.

Warranty Considerations

Various factors can affect a printer's warranty, such as electrostatic damage,
unsupported consumables, and other actions listed on the following page.
Read your printer warranty carefully.
If MINOLTA-QMS printer failure or damage is found to be directly attributable
to the use of non-MINOLTA-QMS approved consumables, print media, and/or
accessories, MINOLTA-QMS will not repair the printer free of charge. In this
case, standard time and material charges will be applied to service your
printer for that particular failure or damage.
50
2
0.75 mm
H05 VV - F
Warranty Considerations