Table of Contents
Advertisement
Installing the network daughter card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the cables connected to the GPU risers.
4.
Remove the GPU riser 2.
5.
Remove the
interposer.
Steps
1. Remove the LOM filler bracket.
a. Using the Phillips #2 screwdriver, remove the screw that secures the bracket to the system.
b. Slide the bracket out of the slot on the system.
2. Install the LOM bracket.
a. Insert and slide the LOM bracket into the slot on the system.
b. Using the Phillips #2 screwdriver, secure the bracket to the system with a screw
3. Orient the network daughter card to fit the Ethernet connectors or the SFP+ through the slot of the bracket.
NOTE:
NIC port 1 in network daughter card is Gb3, and NIC port 2 is Gb4.
4. Press the network daughter card until the card is firmly seated on the system board connector and the two blue plastic clips to secure
the card in place.
5. Using a Phillips #2 screwdriver, secure the network daughter card to the system board with screws.
Figure 116. Installing the network daughter card
Next steps
1.
Install the interposer.
2.
Install the GPU riser 2.
3. If applicable, connect the cables connected to the GPU risers.
4. Follow the procedure listed in
NOTE:
While replacing faulty storage controller/FC/NIC card with the same type of card, after you power on the
system; the new card automatically updates to the same firmware and configuration of the faulty one. For more
information about the Part replacement configuration, see the
idracmanuals
140
Installing and removing system components
Safety
instructions.
Before working inside your
After working inside your
system.
system.
Lifecycle Controller User's Guide at
www.dell.com/
Advertisement
Table of Contents
