Installing The M.2 Ssd Module - Dell EMC PowerEdge XE2420 Installation And Service Manual

Figure 113. M.2 SSD module removal from BOSS card
Next steps
Replace the M.2 SSD module.

Installing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the primary drive bay assembly.
4. Remove the BOSS riser.
5. Remove the BOSS card from the BOSS riser.
Steps
1. Align the M.2 SSD module at an angle with the connector on the BOSS card.
2. Insert the M.2 SSD module until it is firmly seated in the BOSS card connector.
3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw.
Figure 114. M.2 SSD module installation into BOSS card
Next steps
1. Install the BOSS card into the BOSS riser.
2. Install the BOSS riser.
3. Install the primary drive bay assembly.
4. Follow the procedure listed in the
138 Installing and removing system components
Safety instructions.
Before working inside your
After working inside your system.
system.