Table of Contents
Advertisement
Figure 66. Removing the EDSFF drive bay assembly
Next steps
Replace the EDSFF drive bay
Installing the EDSFF drive bay assembly
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Disconnect the cables to the EDSFF switch backplane.
Steps
1. Holding the edges or the touch points, align and engage the holes on the tray assembly with the guide pins on the chassis front wall
and PSU cage.
2. Slide the whole assembly to chassis back until it's fully seated in place.
3. Tighten the two blue thumbscrews at the rear of the assembly.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
90
Installing and removing system components
assembly.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
