Table of Contents
Advertisement
Figure 64. Removing the second drive bay assembly
Next steps
Replace the second drive bay
Installing the second drive bay assembly
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If removed,
install the drive
4. If removed,
install the RAID controller
5. If applicable, reconnect cables to the RAID controller.
Steps
1. Holding the edges or the touch points, align the holes on the riser bracket with the guides on the chassis.
2. Lower the whole assembly into place and press the touch points until it is fully seated in place.
3. Tighten the one blue thumb screw located at the front of the assembly, and two blue thumb screws located at the rear of the
assembly.
88
Installing and removing system components
assembly.
Safety
instructions.
Before working inside your
backplane.
card.
system.
Advertisement
Table of Contents
