Table of Contents
Advertisement
Figure 76. Installing the air shroud
Next steps
1. Install the
GPU riser 1
or
2.
Install the GPU riser 2.
3. Follow the procedure listed in
Intrusion switch module
Removing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the GPU riser 2.
4.
Remove the NVME riser.
5. Keep the plastic scribe ready.
Steps
1. Disconnect and remove the intrusion switch cable from the connector on the system board.
Observe the routing of the cable as you remove it from the system.
2. Using a plastic scribe, slide the intrusion switch out of the intrusion switch slot.
98
Installing and removing system components
Second drive bay
assembly.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
