Removing Gpu From Gpu Riser - Dell EMC PowerEdge XE2420 Installation And Service Manual

2. Follow the procedure listed in the
3. If removed, install the GPU into the GPU
4. If removed, install the network daughter
5. If removed, install the interposer.
6. If removed, install GPU riser 1
Steps
1. Holding the edges or the touch points, align the holes on the GPU riser bracket with the guides on the chassis.
2. Lower the GPU riser bracket into place and press the touch points until the expansion card riser connector is fully seated on the
system board connector.
3. Tighten the one blue thumb screw located at the front of the assembly, and two blue thumb screws located at the rear of the
assembly.
4. Re-connect the cables to the power interposer board.
Figure 83. GPU riser 2 installation
Next steps
After working inside the system.

Removing GPU from GPU riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the GPU riser 2
4. If applicable, disconnect the cables connected to the GPU.
Steps
1. Open the GPU card holder latch.
2. Press the lock on the bottom of the GPU riser, and slide to release the card holder.
3. Hold the GPU, and pull the GPU until the card edge connector disengages from the expansion card connector on the riser.
Before working inside your
riser.
card.
or second drive bay assembly.
Safety instructions.
Before working inside your
or GPU riser 1.
system.
system.
Installing and removing system components 111