Table of Contents
Advertisement
Figure 59. Installing the drive backplane
Next steps
1. Reconnect all the disconnected cables to the backplane.
2. Install all the drives.
3. Follow the procedure listed in
Removing a EDSFF switch backplane
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove all the EDSFF drives.
4. Remove all the cables that are connected to the EDSFF switch backplane.
5.
Remove the EDSFF switch backplane assembly.
Steps
1. Hold and pull the plunger, and slide the backplane towards rights side.
2. Lift the backplane out of the backplane tray.
After working inside your
system.
Safety instructions.
Before working inside your system.
Installing and removing system components
83
Advertisement
Table of Contents
