Table of Contents
Advertisement
Figure 67. Installing the ESDFF drive bay assembly
Next steps
1. Connect the cables to the EDSFF switch backplane.
2.
After working inside the system
.
Control panel
Removing the control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the primary drive bay assembly.
Steps
1. Disconnect the control panel cable from the control panel connector.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Using a Phillips #1 screwdriver, remove the screws that secure the control panel assembly to the server chassis.
3. Move the control panel assembly towards the left to release the lock and pull the assembly out of the server chassis.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
91
Advertisement
Table of Contents
