Table of Contents
Advertisement
Figure 107. Removing the MicroSD card
Next steps
Install the MicroSD
cards.
Installing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
NOTE:
To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
Ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the cards
during removal.
Steps
1. Locate the MicroSD card slot on the IDSDM module. Orient the MicroSD card appropriately and insert the contact-pin end of the card
into the slot. To locate IDSDM, see the System board jumpers and connectors section.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2. Press the card into the slot to lock it into place.
safety instructions
before working inside the system.
Installing and removing system components
133
Advertisement
Table of Contents
