Table of Contents
Advertisement
Next steps
Replace the power interposer
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
Insert the power interposer board into the guides and then lower it until the plunger click into place.
Figure 121. Power interposer board installation
Next steps
1. Install the
PSU.
2. Reconnect all the cable that were removed.
3. Follow the procedure listed in
System board
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create
a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this
system board, you must supply the recovery key when you restart your system or program before you can access the
encrypted data on your drives.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the following components:
a.
Primary drive bay assembly
144
Installing and removing system components
board.
Safety
instructions.
Before working inside your
After working inside your
Safety
instructions.
Before working inside your
system.
system.
system.
Advertisement
Table of Contents
