Table of Contents
Advertisement
Figure 77. Intrusion switch removal
Next steps
Replace the intrusion
switch.
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the GPU riser 2.
4.
Remove the NVME riser.
Steps
1. Align and slide the intrusion switch in the slot until it is firmly seated in the slot on the system.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
2. Connect the intrusion switch cable to the connector on the system board.
Figure 78. Intrusion switch installation
Safety
instructions.
Before working inside your
system.
Installing and removing system components
99
Advertisement
Table of Contents
