Table of Contents
Advertisement
Figure 106. Installing the IDSDM module
Next steps
1.
Install the MicroSD
cards.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during
removal.
2. Follow the procedure listed in the
Micro SD card
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the IDSDM
module.
Steps
1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. For more information on
the slot location, see System board jumpers and connectors section.
2. Hold the MicroSD card and remove it from the slot..
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
132
Installing and removing system components
After working inside your system
Safety instructions
on page 53.
Before working inside your system
on page 54.
on page 54.
Advertisement
Table of Contents
