Table of Contents
Advertisement
Figure 61. EDSFF switch backplane board installation
Next steps
1.
Install the EDSFF switch backplane assembly.
2. Connect all the cables to the EDSFF switch backplane.
3.
Install all the EDSFF drives.
4. Follow the procedure listed in
Primary drive bay assembly
Removing the primary drive bay assembly
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Disconnect all the cables connected to the backplane.
NOTE:
Observe the routing of the cable as you remove it from the system.
Steps
1. Loosen the blue thumb screw located at the rear of the assembly.
2. Slide the assembly towards the front to unlock the assembly.
3. Lift the assembly out of the server.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
85
Advertisement
Table of Contents
