Table of Contents
Advertisement
Figure 54. Cooling fan cables installation
Next steps
1.
Install the air shroud.
2.
Install the NVME riser.
3. Install the
GPU riser 1
or
4.
Install the GPU riser 2.
5.
Install the cooling fan backplane.
6.
Install all the cooling fans.
7. Follow the procedure listed in
Drive backplane
Drive backplane
Depending on your system configuration, the drive backplanes that are supported are listed here:
Table 36. Supported backplane options
System
PowerEdge XE2420
NOTE:
In 2C configuration, hard drive slots 2 and 3 do not support NVMe drives if only processor 1 is installed.
second drive bay
assembly.
After working inside your
Configuration
1A (Primary backplane module)
2C (Primary backplane module + Secondary
backplane 2 module)
3A (EDSFF Switch backplane)
system.
Installing and removing system components
Supported hard drives options
2 x 2.5-inch SATA/NVMe
2 x 2.5-inch SAS/SATA/NVMe + 2 x 2.5-
inch SAS/SATA/NVMe
6 x EDSFF E1.L drives
79
Advertisement
Table of Contents
