Installing The Network Daughter Card - Dell EMC PowerEdge C4140 Installation And Service Manual

Figure 40. Removing the network daughter card
Next step
Install the NDC.

Installing the network daughter card

Prerequisite
Follow the safety guidelines listed in
Steps
1 Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
2 Align the captive screws at the back-end of the card with the screw holes on the system board.
3 Press the touch points on the card until the card connector is firmly seated on the system board connector.
4 Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
84 Installing and removing system components
Safety instructions.