Table of Contents
Advertisement
Table 47. Riser configuration 3A (continued)
Card type
Broadcom (25 G PCIe LP)
Intel 25 G (SFP)
Intel 25 G (SFP LP)
Mellanox 100 G (CX6 H100)
Internal storage (BOSS)
Nvidia GPU DW
Nvidia T4 GPU SW
OCP (2x10 G)/(2x25 G)
Removing the GPU riser 2
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Disconnect the cables connecting to PIB.
2. Loosen the one blue thumbscrew at the front of the assembly, and two blue thumbscrews at the rear of the assembly.
3. Hold the touch points, and lift the expansion card riser from the riser connector on the system board.
Figure 82. GPU riser 2 removal
Next steps
Replace the primary backplane
Installing the GPU riser 2
Prerequisites
1. Follow the safety guidelines listed in the
110
Installing and removing system components
Slot priority
6
3, 5, 4, 2
6
3, 5
7
3, 5
3, 5, 4, 2
1
Safety
instructions.
Before working inside your
assembly.
Safety
instructions.
system.
Maximum number of cards
1
4
1
2
1
2
4
1
Advertisement
Table of Contents
