2.
Install the air
shroud.
3.
Install the
sled.
4. Follow the procedure listed in
Network daughter card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the sled.
4.
Remove the air shroud.
5.
Remove the PCIe card module.
6.
Remove the mini PERC module.
Steps
1. Push the blue retention clips away on one side and release the OCP card. Repeat step 1 to release the card from the clips on
the other side.
2. Slide the card toward the front of the sled to disengage the connectors from the chassis and lift the card up.
Figure 59. Removing the OCP card
Next steps
Install the OCP
Card.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
93