Table of Contents
Advertisement
Figure 123. System board removal
Next steps
Install the system
board.
Installing the system board
Prerequisites
NOTE:
Before replacing the system board, replace the old iDRAC MAC address label in the Information tag with the
iDRAC MAC address label of the replacement system board
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If you are replacing the system board, remove all the components that are listed in the
Steps
1. Unpack the new system board assembly.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the chassis.
2. Holding the system board holder, lower the system board it into the system.
3. Incline the system board at an angle and align the connectors with the slots on the front of the chassis.
4. Slide the system board towards the front of the chassis until the connectors are firmly seated in the slots.
146
Installing and removing system components
Safety
instructions.
Before working inside your
system.
removing the system board
section.
Advertisement
Table of Contents
