Boss Riser And M.2 Module; Removing The Boss Riser - Dell EMC PowerEdge XE2420 Installation And Service Manual

Figure 108. Installing the MicroSD card
Next steps
1. Install the IDSDM module.
2. Follow the procedure listed in the

BOSS riser and M.2 module

Removing the BOSS riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the primary drive bay
Steps
Hold the BOSS riser by its edges, and pull the riser until the riser edge connector disengages from the expansion card connector on the
system board.
134 Installing and removing system components
after working inside the system.
Safety instructions.
Before working inside your
assembly.
system.