Installing The Network Daughter Card - Dell EMC PowerEdge R630 Owner's Manual

3. captive screw (2)
5. NDC
Related references
安全说明
on page 72
Related tasks
拆装系统内部组件之前
on page 73
Removing expansion card risers

Installing the network daughter card

Identifier
Version
Status
Installing the network daughter card
多数维修只能由经认证的维修技术人员进行。您只能根据产品说明文件中的授权，或者在联机或电话服务和支持
CAUTION:
团队的指导下进行故障排除和简单维修。任何未经 Dell 授权的服务所导致的损坏均不在保修范围之列。请阅读并遵循您的
产品附带的安全说明。
CAUTION: If the GPU card is installed, you cannot install the 10 GbE Network Daughter Card (NDC).
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Philips #1 screwdriver handy.
If the 系统 has three PCIe cards, ensure that you install the PCIe cooling shroud in your 系统.
NOTE:
1. Orient the NDC so that the Ethernet connectors fit through the slot in the back panel.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. To ensure that the connector on the card is in contact with the connector on the system board, press the touch point on the
card.
4. Tighten the two captive screws to secure the NDC to the system board.
5. Install the expansion card riser 3.
on page 107
on page 121
GUID-5231339C-BA70-4CA1-B90E-404CF30F30E3
5
Released
4. touch point (2)
6. back panel slots for Ethernet connectors
安装和卸下系统组件
121