Table of Contents
Advertisement
Figure 72. Cable routing - 6 x EDSFF switch backplane
PERC
Removing the PERC from the second drive bay assembly
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the second drive bay assembly.
Steps
1. Open the PCIe card holder latch.
2. Rotate the second drive bay assembly to press the card holder lock, and slide to release the card holder.
3. Hold the PERC card by its edges, and pull the card until the card edge connector disengages from the expansion card connector on
the assembly.
94
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
