Table of Contents
Advertisement
Figure 101. Removing the network daughter card
Next step
Install the
NDC.
Installing the network daughter card
Prerequisite
Follow the safety guidelines listed in
Steps
1
Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
2
Align the captive screws at the back-end of the card with the screw holes on the system board.
3
Press the touch points on the card until the card connector is firmly connected to the connector on the system board.
4
Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
Safety
instructions.
Installing and removing system components
145
Advertisement
Table of Contents
