Table of Contents
Advertisement
Figure 40. Removing the Network Daughter Card
Next step
1
Install the
NDC.
Installing the Network Daughter Card
Prerequisite
CAUTION:
To prevent damage to the Network Daughter Card (NDC), you must hold the card only by its edges.
1
Follow the safety guidelines listed in
Steps
1
Align the following:
a
The slots on the card edge with the projection tabs on the plastic bracket covering the mezzanine card slots.
b Screw holes on the card with the standoffs on the system board.
2
Lower the card into place until the card connector fits into the corresponding connector on the system board.
3
Using the Phillips #2 screwdriver, replace the screws to secure the card.
Safety
instructions.
Installing and removing system components
83
Hide quick links:
Advertisement
Table of Contents
