Installing Network Daughter Card - Dell EMC PowerEdge R840 Installation And Service Manual

Steps
1 Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
2 Hold the NDC by the edges, and lift to disengage it from the connector on the system board.
3 Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back of the system.
Figure 74. Removing network daughter card
Next step
1 Replace the Network daughter

Installing network daughter card

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
4 Remove the expansion card riser
Steps
1 Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
2 Align the captive screws on the card with the screw holes on the system board.
3 Press the touch points on the card until the card connector is firmly seated on the system board connector.
4 Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
108 Installing and removing system components
card.
Safety instructions.
Before working inside your
1.
system.