Table of Contents
Advertisement
Figure 65. Removing the second drive bay assembly
Next steps
1. Connect the interposer cable at slot B1, PIB cables, cable on the primary backplane, and slimline cable on the secondary drive
backplane.
2.
Install the GPU riser 2
3.
After working inside the system
.
Removing the EDSFF drive bay assembly
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Disconnect cables that are connected to the EDSFF switch backplane.
NOTE:
Observe the routing of the cable as you remove it from the system.
Steps
1. Loosen the two blue thumbscrews at the rear of the assembly.
2. Hold the touch points, and slide the assembly towards the chassis front and lift it out of the system.
Safety
instructions.
Safety
instructions.
Installing and removing system components
89
Advertisement
Table of Contents
