Festo VTSA Series Description page 67

2. Mounting
Variant
VTSA... valve terminal with CPX terminal
2
VTSA... valve terminal with multi−pin node
1
Tab. 2/2: Holes for the H−rail clamping unit
Assembly
Festo P.BE−VTSA−44−EN en 0905e
1
Proceed as follows:
1. Make sure that the mounting surface can support the
weight of the valve terminal (for weights, see Appendix A,
Tab. A/2).
2. Mount the H−rail (DIN mounting rail EN 60715 − 35x7.5;
width 35 mm, height 7.5 mm). Make sure there is suffi
cient space for connecting the power supply cables and
tubing.
3. Fasten the H−rail to the mounting surface at intervals of
approx. every 100 mm.
Mounting option
Hole for the H−rail clamping
units:
1 In the pneumatic interface
below the inscription field
2 In the end plates
2
Hole for the H−rail clamping unit:
1 In the multi−pin node
2 In the right end plate
2
2−7