Festo VTSA Series Description page 198

B. Supplementary overview of components
B−16
4. Insert the retaining screws in the appropriate holes.
Tighten the screws in the sequence 1 3 4 2
(see following diagram) at first slightly and then
with 3.0 Nm.
1
4
Fig. B/4: Mounting the VTSA... valve terminal on the pneu
matic interface
5. Fasten the valve terminal onto the mounting surface (see
Chapter 2 in this description or the CPX system manual).
6. Complete the electrical and pneumatic connections of
the VTSA... valve terminal with CPX terminal or FB 21
(type 03). Information on this can be found
in the pneumatics section in Chapter 3 of this descrip
tion
in the section on electric components for VTSA valve
terminal with CPX terminal in the CPX system manual
in the section on electric components for VTSA valve
terminal with FB 21 in the FB 21 (type 03) electronics
description
Festo P.BE−VTSA−44−EN en 0905e
2
3