Stop The Status Display Scrolling; Change The Contrast On 7 Segment Displays; Display Power Saving Mode - HySecurity StrongArm 14F Programming And Operations Manual

The following chart describes the scrolling status displays in the StrongArm models.
Operator Status Display
Build Year
Dual Gate or Sequenced Gate
Operator Type (OT)
Set Handing (SH)
Usage Class (UC)
Input Voltage VDC
Cycle Count (CC)
Close Timer (CT)

Stop the Status Display Scrolling

To stop the operator status display scroll and focus on one item, press Select. Press Select a second time, to
resume the scrolling display.

Change the Contrast on 7 Segment Displays

NOTE: Since sunlight does not affect readability on the OLED display, changing the display contrast is not available on models
shipped with the 32 character display.
While the operator status displays are scrolling, you can change the contrast by pressing the up or down arrow
keys. The display's contrast changes accordingly.

Display Power Saving Mode

To conserve energy, the display dims after a period of time if no keypress, run command or fault occurs. When
an event (keypress, run command, or error/alert/fault notification) occurs, the display returns to full brightness.
62
hysecurity.com | 800-321-9947
Variables
Indicates whether the gate operator was
manufactured before or after UL 325 -
2016 Safety of Standard changes that
require monitoring of external entrapment
sensors.
This display only appears when the
operator is used in interlocked or
sequenced gate systems and indicates the
function of the operator. See Bi-Parting
& Dual Gate Systems on page 85 and
Integrating with Security Systems and
HyNet™ Gateway on page 77.
OT 1 = StrongArm
OT 7 = StrongArm 50VF series
L = Left and R = Right
1, 2, 3, or 4
The number varies depending on the
voltage that the power board is providing.
One cycle equals a full open and close
sequence. Partial cycles are not counted
The first menu item in the User Menu.
StrongArm Programming and Operations
Description
All gate operators manufactured in 2016
or later will show Build Year - Post 2016
because it contains software version h4.50.
If you plan to upload 4.50 software (or
later) into your gate operator, you will need
to set the appropriate build year according
to the date of manufacture.
Indicates, in an interlocked or dual gate
setting, whether the operator is set to
Primary or Secondary or Sequenced Gate
Configuration). The setting is assigned in
the Installer Menu.
Indicates and identifies the operator.
Indicates gate handing.
Displays the operator's Usage Class
designation per UL 325 standards.
Input voltage (DC Buss voltage) to the
STC is shown. Helps to determine proper
power connections.
Displays the number of cycles the gate
operator has incurred. Similar to an
odometer, it resets to zero after 999,999
cycles.
Displays the number of seconds before the
open gate initiates. NOTE: You can also
access the Installer Menu from this display.
MX3657-01 Rev. D ©2020