Wiring Tips For Sensor Com Terminal: Smart Touch; Menu Mode Navigational Tips - HySecurity StrongArm 14F Programming And Operations Manual

W t
irinG iPs for
Two SENSOR COM terminals exist (Terminal 14 and Terminal 15). If using multiple sensor devices, use a wire
nut as a junction and pigtail to SENSOR COM. Or, install a separate terminal block and jumper outputs to one
lead for either SENSOR COM terminal.
CAUTION
All external entrapment protection sensors must be NC sensor outputs and wired to the SENSOR COM terminal for
monitoring and powering purposes. The sensor becomes actively powered when the gate operator receives a run command.
Wires coming from
sensor device
Connect
sensor's "Relay
COM"wiring
to Terminal 14
or 15
(SENSOR COM)
Wire nut and pigtail to SENSOR COM
NOTE: LEDs next to the sensor connections will be lit when NO POWER is being applied. To temporarily supply power to the
sensors. Refer to Photo Eye Alignment Feature on page 104. When PE is turned ON, the LEDs turn off. If they do not turn off,
check for wiring issues such as a short or misapplied relay COM connections. Refer to Supply Power to the Sensors on page 51.
M M
enu ode
The buttons on the display keypad perform certain functions while in Menu Mode. Refer to the chart.
To change data
appearing in the display
Press Select.
Two left characters blink.
122
hysecurity.com | 800-321-9947
sensor CoM t
12 SHADOW/RESET
VEHICLE DETECTOR
SENSOR 1
14
SENSOR COM
15
16
DO NOT USE
17
SENSOR 2
18
DO NOT USE
19
SENSOR 3
20
DO NOT USE
CHARGER
21
AC LOSS
22
LOCK INTERLOCK
23
EMERG CLOSE
24
FIRE DEPT OPEN
Smart Touch Controller
LED
LIMIT DUAL GATE
RPM
COM A B COM
n
aViGational
To navigate through
the Selections
Press Next or Previous.
Continue pressing Next to view
all selections.
erMinal
Wires coming
from sensor
device
Wire to
SENSOR
COM
Add terminal block
t
iPs
To choose what appears
on the display
Press Select.
Blinking characters
become static.
StrongArm Programming and Operations
: s t
Mart ouCh
To navigate between
menu items
Press Next or Previous.
Advance - press Next
Previous - press Previous
MX3657-01 Rev. D ©2020