Smart Touch: Wired Edge Sensor With Gem (-104) - HySecurity StrongArm 14F Programming And Operations Manual

s t
Mart ouCh
1. Turn OFF power.
2. Connect the Green
3. Connect Red & Green wires from GEM-104 to SENSOR COM on Controller (or Power Supply
Board, STC).
4. Connect Red wire from GEM-104 to +24V on Controller
(or Power Supply Board, STC).
5. Connect Black & White wire from GEM to 10K resistor in
edge sensor.
6. Turn ON power and access the Installer Menu. Configure
SENSOR setting accordingly (i.e. Edge Open, Edge
Close, or Edge Both). Refer to Table 4: HySecurity Gate
Operators maintaining Object Detection on page 29.
CAUTION
All external entrapment protection sensors
must be NC sensor outputs and wired to the
SENSOR COM terminal for monitoring and
powering purposes. The sensor becomes
actively powered when the gate operator's
motor runs.
Power Supply
Board
Black & White
Wires
*NOTE: Make sure whichever wired input used (SENSOR 1, 2, or 3) is the
same Sensor # configured through the Installer Menu.
Wiring HySecurity Sensors: Smart Touch
MX3657-01 Rev. D ©2020
: W e
ired dGe
NC relay wire from GEM-10 to Sensor 1, 2, or 3.
GEM: Red Wire
CONNECT TO GATE EDGE
WITH 10K OHM RESISTOR
B W
MILLER EDGE
GEM
Green output wire can attach
to any SENSOR input.
s
ensor With
S2 0
SENSOR #2 TYPE
DRIVE
1
2
3
4
5
6
7
8
9
10
11
12
GEM:
Red Wire
14
GEM:
15
Green Wire
16
17
GEM: 18
Green Wire
19
20
21
22
23
24
LIMIT
hysecurity.com | 800-321-9947
GeM (-104)
Installer Menu
showing Sensor 2
set to Edge Open
(Option #5)*
S2 5 (EDGE OPEN)
SENSOR #2 TYPE
POWER
STOP BUTTON
OPEN BUTTON
CLOSE BUTTON
REMOTE OPEN AND
RADIO CONTROL
OPEN/CLOSE
OPEN PARTIAL
INTERLOCK OPEN
TIME CLOCK OPEN
FREE EXIT DETECTOR
DISABLE EXIT DETECTOR
DISABLE CLOSE TIMER
INSIDE OBSTRUCTION
VEHICLE DETECTOR
OUTSIDE OBSTRUCTION
VEHICLE DETECTOR
SHADOW/RESET
VEHICLE DETECTOR
SENSOR 1
SENSOR
COM
DO NOT USE
SENSOR 2
DO NOT USE
SENSOR 3
DO NOT USE
CHARGER
AC LOSS
HySecurity
LOCK INTERLOCK
MX000585
VERSION
S/N
EMERG CLOSE
FIRE DEPT OPEN
Smart Touch Controller
LED
RADIO OPTIONS
DUAL GATE
RPM
COM A B COM OPEN +24V +24V
RS485
COM
NO
STATUS
S 1
COM
123