Stop The Status Display Scrolling; Change The Display Contrast; Check Time And Date - HySecurity SlideDriver 15 Programming & Operation Manual

The following chart describes the scrolling status displays in the SlideDriver or SlideDriver 50VF-series.
Operator Status Display
Software Version
A lower case "h" appears in front of the
software version number.
Dual Gate or Sequenced Gate
Operator Type (OT)
Set Handing (SH)
Usage Class (UC)
Battery Voltage
Cycle Count (CC)
Close Timer (CT)

Stop the Status Display Scrolling

To stop the operator status display scroll and focus on one item, press Select. Press Select a second time, to
resume the scrolling display.

Change the Display Contrast

While the operator status displays are scrolling, you can change the contrast by pressing Select, and then
pressing the up or down arrow keys. The display's contrast changes accordingly. To exit, press Select again and
the operator status displays continue to scroll and stop at the User Menu entry item.
NOTE: Since sunlight does not affect readability on the OLED display, changing the display contrast is not
available on SlideDriver models shipped with the 32 character display.

Check Time and Date

An easy way to determine if your operator is set for the correct date and time zone can be accomplished by
taking the following steps:
1. While in Run mode (gate status appears in the display), press and hold the STOP button.
The date appears DD/MM, and then the time HH:MM.
2. If you need to change the time zone, refer to the Set Clock "CL" item in the User Menu. Refer to User
Menu: Table 1 on page 39.
38
D0559 Rev. A
Variables
The software version and revision number
are hard-coded in the Smart Touch
Controller.
This display only appears when the
operator is used in interlocked or
sequenced gate systems and indicates the
function of the operator: Cfg 1 or Cfg 2
(Configuration 1/2)
OT 1 = SlideDriver
OT 7 = SlideDriver 50VF series
L = Left and R = Right
1, 2, 3, or 4
This display only appears when a DC
power source is being used. The number
varies depending on the voltage that the
charger is providing.
One cycle equals a full open and close
sequence. Partial cycles are not counted
The first menu item in the User Menu.
SlideDriver/SlideDriver 50VF Series
Description
Displays the software version when you
press Reset or cycle power. You will need
the software version when calling Technical
Support.
Indicates, in an interlocked or dual gate
setting, whether the operator is set to
Primary or Secondary or Configuration 1 or
2 (Sequenced Gate setting). The setting is
assigned in the Installer Menu.
Indicates and identifies the operator.
Indicates gate handing.
Displays the operator's Usage Class
designation per UL 325 standards.
Input voltage (DC Buss voltage) to the STC is
shown.
Displays the number of cycles the gate
operator has incurred. Similar to an odometer,
it resets to zero after 999,999 cycles.
Displays the number of seconds before the
open gate initiates. NOTE: You can also
access the Installer Menu from this display.
www.hysecurity.com