Test 08, Service Mode Diagnostics - Xerox Telecopier 7033 Service Manual

Test 06, Interface Trace Print
(Engineering Use Only)
This test provides a printout of a CPU trace.
1. Enter service mode.
2. Press 0 and 6 on the keypad, then press
Enter. The display will indicate:
06 INTERFACE TRACE PRINT
PRESS [START] OR [STOP]
3. Press Start. The display will indicate:
06 INTERFACE TRACE PRINTING
PRESS [STOP] TO END
When printing is complete, the terminal will
return to idle mode.
Telecopier 7032 / 7033 Service Manual
Test 07, Memory Dump Printout
(Engineering Use Only)
This test provides a printout of the memory
contents in the S-RAM and D-RAM.
1. Enter service mode.
2. Press 0 and 7 on the keypad, then press
Enter. The display will indicate:
07 MEMORY DUMP PRINT
PRESS [START] OR [STOP]
3. Press Start. The display will indicate:
ADDRESS > _ SIZE >
ENTER ADDRESS THEN PRESS [ENTER]
4. Enter the memory location.
a. 700000 (S-RAM), or
800000 (D-RAM), or
900000 (1 or 3 megabyte memory
expansion)
b. Press Enter. The display will indicate:
ADDRESS > XXXXXX SIZE > BYTE
PRESS [SELECT] TO CHANGE SIZE
5. Select the printout format.
a. Press Select to choose BYTE, WORD, or
LONG.
BYTE= columns of two characters
WORD= columns of four characters
LONG= columns of eight characters
6/92
www.printcopy.info
6-11
Test 07, Memory Dump Printout (continued)
6. Press Start. The display will indicate:
07 MEMORY DUMP PRINTING
PRESS [STOP] TO END
When printing is complete, the terminal will
return to idle mode.
Test 07, Service Mode Diagnostics
Refer to 6.2.6
Test 10, Softswitch Setup
Refer to Appendix A, A1
6.2.4