Xerox Telecopier 7033 Service Manual page 230

1.5 Installation
1.5.1 Auxiliary Tray Assembly
1. Remove auxiliary tray assembly from carton and verify contents.
• auxiliary tray assembly
• paper guide
2. On the terminal, remove the following:
a. both output trays and the paper tray
b. right side cover (REP 4.1.2)
c. metal end plate located under the right side cover
d. rear cover (REP 4.1.7)
3. Set the terminal on its left side and remove both operator guide
holders.
4. On the auxiliary tray assembly, remove the paper tray and the rear
cover.
5. Insert (do not tighten) the three rear mounting screws on the
auxiliary tray assembly (Figure 1). Leave the screws loose enough
for the brackets on the terminal to slide through.
Telecopier 7032 / 7033 Service Manual
• right side cover
• hardware (in bag)
www.printcopy.info
Auxiliary tray
wire harness
Figure 1. Auxiliary tray installation, rear screws
6. Join the auxiliary tray assembly to the terminal. Secure the front
with three screws, and tighten the three rear screws (Figure 2).
7. Perform the following:
a. Install the operator guide holders on the bottom of the
auxiliary tray assembly.
b. Connect P/J194 at the bottom of the electrical box.
c. Install the drive belt on the paper input roller gear (Figure 3).
NOTE: If there is excessive slack in the drive belt after installing
the belt on the gear, loosen the auxiliary tray mounting screws
and bias the tray unit away from the terminal to remove the
slack. Do not over tighten belt.
Retighten the screws.
6/92
8a-6
Machine
Top
Machine
Front
Auxiliary tray
7033-278
1/8 inch travel is normal.
1.5.1