Xerox Telecopier 7033 Service Manual page 246

G3 PWB
P/J32
Modem
connector
Coupler
PWB (RX)
Figure 2. Encryption interface cable routing
1.5.1
Modem PWB
Encryption
interface PWB 7033-284
www.printcopy.info
6. Connect the encryption interface PWB to J2 on the option mother
PWB.
NOTE: For proper operation, the encryption interface PWB must
be located in slot J2. If another option is already installed, move
that board to J3.
7. Replace the rear access cover using two black screws and connect
all cords/cables that were disconnected in step 3.
8. Connect the Y-cable for the encryptor.
9. Mark the installation date on the product feature index label
located under the donor film housing.
10. Connect power to the terminal and enter service mode.
11. Enter soft switch mode.
a. Press 1then 0 then [Enter].
b. Press [Start] two times.
c. Select soft switch 013 and set bit 0 and bit 1 to"1".
Example: SS 013 = 00010111
NOTE: This places the terminal in G3 mode only. Encryption does
not function in a G2 operation.
12. Exit service mode.
13. If an encryption device has not been provided. Connect the two
ends of the Y cable together.
operation for G3 only.
6/92
8c-6
This will allow normal machine
Telecopier 7032 / 7033 Service Manual