Xerox Telecopier 7033 Service Manual page 153

Protocol Monitor Print (continued)
4. Protocol monitor sample legend. (See Figure 1.)
1. Header Print:
Same header printed on Activity Report and Options Report.
2. Activity Log Field:
Same log printed on Activity Report.
3. EQM (Eye Quality Monitor):
A hex value printed in the activity log field that indicates the
quality of the line. Values are shown below.
Line Quality
Best Worst
00 . . . . . . . . . . . . 7F
4. Att (Attenuation):
Also printed in the activity log field of the Activity Report
when the terminal is in service mode. The printed value in
hex indicates the received signal level in dbm's. Values are
shown in Table 1.
5. S/W Version:
Prints the firmware version levels for the RAM/ROM and G3
PWB's. This information is also printed on the Options
Report when the terminal is in service mode.
6. Lapse:
The lapse time in minutes and seconds for the operation.
7. Local:
The mnemonics listing of all signals sent by the local
terminal.
8. >
Shows signal flow direction to and from the local to remote
terminal.
9. Remote:
The mnemonic listing of all signals sent by the remote
terminal.
10. FCF (Facsimile Control Field) Engineering use only.
11. FIF (Facsimile Information Field) Engineering use only.
6.2.4
Line disconnected
FF
6/92
www.printcopy.info
6-10
Table 1. Attenuation
Hex Signal
Value Level (dBm)
00 0
01 -1
02 -2
03 -3
04 -4
05 -5
06 -6
07 -7
08 -8
09 -9
0A -10
0B -11
0C -12
0D -13
0E -14
0F -15
10 -16
11 -17
12 -18
13 -19
14 -20
15 -21
16 -22
17 -23
18 -24
Telecopier 7032 / 7033 Service Manual
Hex Signal
Value Level (dBm)
19 -25
1A -26
1B -27
1C -28
1D -29
1E -30
1F -31
20 -32
21 -33
22 -34
23 -35
24 -36
25 -37
26 -38
27 -39
28 -40
29 -41
2A -42
2B -43
2C -44
2D -45
2E -46
2F -47
30 -48 or less