Table of Contents
Advertisement
Perform the indicated steps to remove a desired part.
Separator Shaft Lever
Separator Shaft
Separator Shaft Lever Linkage
Linkage #1
Linkage #2
Donor Film Support Assembly (Front, Left, or Right)
Belt, Donor Film Drive Assembly
Donor Film Support (Left, Rear)
Donor Film Support (Right, Rear)
Pulley, Donor Film Drive Assembly Pulley
Pulley, Donor Film Drive Assembly
Paper Feed Solenoid
Donor Film Indicator and Spring
Donor Film Indicator Linkage
Removal
1.
Remove printer cover assembly. (PL 5.1A)
a. Disconnect power cord.
b. Lower the right side cover.
c. Open printer top cover.
d. Loosen four top cover screws.
e. Partially close the upper printer, and remove the cover.
left end must be lifted up first, and then slide the cover away
from upper printer hinge shaft.
2.
Remove right side cover. (PL 5.1A)
a. Lower the right side cover.
b. At the terminal frame, remove the screw securing the nylon
restraint.
4.5 Lower Printer Assembly
3
4
32
3
4
32
33
3
4
32
34
3
4
5
35
3
4
36
3
4
37
3
6
7
8
9
3
6
7
8
9
3
6
7
8
9
3
6
7
8
9
3
6
7
8
9
3
6
7
8
9
44
44
45
c. Single tray unit. Slide door away from frame.
d. Double tray unit. Slide auxiliary paper tray out approximately
4 to 6 inches.
e. Double tray unit.
then pull out back end of door from frame.
3.
Remove left side cover. (PL 5.1A)
The
a. Disconnect power cord.
b. Remove document and copy output trays.
c. Remove three (3) screws securing left side cover.
d. Slide out left side cover.
8/91
www.printcopy.info
4-29
10
38
10
39
10
38
40
38
41
10
38
41
42
43
Slide front end of door away from frame,
Telecopier 7032 / 7033 Service Manual
Advertisement
Chapters
Table of Contents
