Xerox Telecopier 7033 Service Manual page 83

8. Remove stop shaft. (PL 5.6A)
a. Remove E-ring from front of stop shaft, and remove linkage
arm (Figure 5).
Stop
Remove
shaft
E-rings
Figure 5. Stop shaft removal
b. Remove E-ring from rear inside end of stop shaft (Figure 5).
c. Remove E-ring from rear outside end of stop shaft (Figure 5),
and slide shaft out through the front of terminal
Telecopier 7032 / 7033 Service Manual
Remove
E-ring
Stop
shaft
7033-251
www.printcopy.info
9. Remove primary pulley (67T). (PL 5.6A)
a. Remove drive belt from pulley.
b. Loosen set screw in pulley, and remove pulley (Figure 6).
Set
Gear
screw
Drive
belt
Replacement
(View rotated 90°)
End of
shaft flush
with gear
Figure 6. Pulley removal
8/91
4-25
7033-252
4.4 Upper Printer Assembly