Xerox Telecopier 7033 Service Manual page 152

Test 02, Test Pattern Type B
This pattern checks for waste in the donor film
mechanical system and alignment of the
thermal head mechanical system.
1. Enter service mode.
2. Select Test 02.
a. Press 0 and 2 on the keypad, then press
Enter. The display will indicate:
02 PATTERN-B PAGES >01
PRESS [START] OR [STOP]
b. Using the keypad, enter the desired
number to print.
c. Press Start. The display will indicate:
02 PATTERN-B PRINTING
PRESS [STOP] TO END
When printing is complete, the terminal will
return to the idle mode.
Telecopier 7032 / 7033 Service Manual
Test 03, Test Pattern Type C
This is a printout of the character generator.
1. Enter service mode.
2. Select Test 03.
a. Press 0 and 3 on the keypad, then press
Enter. The display will indicate:
03 PATTERN-C PAGES >01
PRESS [START] OR [STOP]
b. Using the keypad, enter the desired
number to print.
c. Press Start. The display will indicate:
03 PATTERN-C PRINTING
PRESS [STOP] TO END
When printing is complete, the terminal will
return to the idle mode.
Figure 1. Protocol monitor sample
6/92
www.printcopy.info
6-9
Test 05, Protocol Monitor Print
Enables monitoring and printing
facsimile protocol sequence
facsimile transaction. The method of printing
is selected via Soft Switch Set Up.
1. Enter service mode.
2. Press 0 and 5 on the keypad, then press
Enter. The display will indicate:
05 PROTOCOL MONITOR PRINT
PRESS [START] OR [STOP]
3. Press Start. The display will indicate:
05 PROTOCOL MONITOR PRINTING
PRESS [STOP] TO END
When printing is complete, the terminal will
return to idle mode.
of the
of the last
6.2.4