Service Mode; Remote Diagnostics; Service Mode Tests - Xerox Telecopier 7033 Service Manual

6.2.3 Remote Diagnostics

Purpose
The function of remote diagnostics is to allow
a central test terminal to control specified
functions in a remote customer terminal.
Customer terminal configurations
USO: This feature is incorporated
production terminals and can be set
from the control panel by the operator
to an OFF or ON status.
terminals will have Remote Test Enable
(Diagnostics) turned ON when shipped.
RX: This feature is incorporated
production terminals and is controlled
by a DIP switch bit mounted on the G3
PWB (refer to 6.1.1).
terminals will have Remote Test Enable
(Diagnostics and the DIP switch bit)
turned OFF when shipped.
Operation
The central test terminal is able to initiate
individual tests that do not require direct
observation of terminal functions.
Soft Switch 090 bit "0" must be set to "1" for
the central test terminal to
remote diagnostic test.
00000001 = ON
00000000 = OFF
6.2.3, 6.2.4
6.2.4

Service Mode Tests

The following diagnostic routines are included
in service tests. All of these tests are described
in this section, except where noted.
Test # Description
01 Test Pattern Type A
02 Test Pattern Type B
in all 03 Test Pattern Type C
04 Service Mode Options Report
(refer to 6.2.5)
Production
05 Protocol Monitor Print
06 Interface Trace Print
07 Memory Dump Printout
in all 08 Service Mode Diagnostics (refer
to 6.2.6)
09 Reserved
Production
10 Soft Switch Set Up (refer to
Appendix A)
11 Reserved
12 Reset Counters
13 RAM Clear
14 Original Feed Test
15 LED Array Test
16 Sensor Test
17 Frequency Test
18 Touch Tone Test (DTMF
perform the
generator)
19 Reserved
20 Hard Drive Exerciser Test
21 Reserved
22 RS-232 Loopback Test
www.printcopy.info
Test 01, Test Pattern Type A
Internally generated test pattern.
same test pattern that is printed at the end of
self test.
1. Enter service mode.
2. Select Test 01.
When printing is complete, the terminal will
return to the idle mode.
6/92
6-8
a. Press 0 and 1 on the keypad, then press
Enter. The display will indicate:
01 PATTERN-A PAGES >01
PRESS [START] OR [STOP]
b. Using the keypad, enter the desired
number to print.
c. Press Start. The display will indicate:
01 PATTERN-A PRINTING
PRESS [STOP] TO END
Telecopier 7032 / 7033 Service Manual
This is the