Xerox Telecopier 7033 Service Manual page 66

6. Remove upper scanner assembly. (PL 5.2A)
a. Disconnect nudger solenoid in-line connector P/J130.
b. Open upper scanner assembly.
c. Remove E-rings from front and rear ends of upper scanner
assembly shaft (Figure 4).
Spring
E-ring
Bearing
Figure 4. Upper scanner removal
d. Slide front plastic bearing off of the front end of the shaft.
e. While holding upper scanner assembly, slide rear bearing off
the rear end of the shaft.
f. Carefully remove upper scanner assembly from terminal.
g. Remove front and rear hinge springs from ends of shaft.
4.2 ADF and Upper Scanner
P/J 130
E-ring
Spring
Bearing
7033-229
www.printcopy.info
7. Remove platen roller. (PL 5.2B)
a. Disconnect power cord.
b. Open upper scanner assembly.
c. Remove input idler shaft belt (Figure 5).
Pulley
E-ring
Bearing
Belt
Figure 5. Platen roller removal
d. Remove E-ring, pulley, and bearing from front end of platen
roller shaft (Figure 5).
e. Remove E-ring and bearing from rear end of platen roller
shaft.
f. Remove platen roller.
8/91
4-8
Bearing
E-ring
Platen roller
Telecopier 7032 / 7033 Service Manual
7033-230