Rap 2.6 Fp10 Error Code - Xerox Telecopier 7033 Service Manual

The voltage is –12 VDC ±1.2 VDC.
Y N
| Replace the power supply.
4. Perform the following:
a. Disconnect the power cord.
CAUTION
Wait until the power supply LED is off
before connecting P/J300.
b. Connect P/J300.
c. Disconnect P/J600 and P/J103 from
the main PWB.
d. If RS-232 and/or encryption PWB are
installed, remove them
option mother PWB.
e. Connect the power
measure the voltage from pin 6 to pin
9 on the main PWB P/J300.
The voltage is –12 VDC ±1.2 VDC.
Y N
| Replace in order:
• G3 PWB
• modem PWB.
• coupler PWB (RX only)
If the problem still exists, replace
the main PWB.
5. Perform the following:
a. Disconnect the power
reconnect P/J600.
b. Reconnect the power
measure the voltage from pin 6 to pin
9 on the main PWB P/J300.
The voltage is –12 VDC ±1.2 VDC.
Y N
| Replace the video assembly.
RAP 2.6
6. Perform the following:
a. Disconnect
reconnect P/J103.
b. Reconnect
measure the voltage from pin 6 to pin
9 on the main PWB P/J300.
The voltage is –12 VDC ±1.2 VDC.
Y N
| Replace the control panel.
7. Replace the option PWB(s).
and the
cord, and
cord, and
cord, and
www.printcopy.info

RAP 2.6 FP10 Error Code

the power cord, and
the power cord, and
8/91
2-20
1. The RS-232 interface and/or hard disk
drive option is installed.
Y N
| Replace in order:
• G3 PWB
• control panel
• main PWB
2. Perform the following:
a. Disconnect the power cord.
b. Remove the option interface PWB(s).
c. Connect the power
perform a self test.
The self test completes without an FP10
error.
Y N
| Replace in order:
• G3 PWB
• control panel
• main PWB
3. The RS-232 interface was installed.
Y N
| Go to step 6.
4. Perform the following:
a. Disconnect the power cord.
b. Reinstall the RS-232 Interface PWB.
c. Connect the power
perform a self test.
The self test completes without an FP10
error.
Y N
| Replace the RS-232
PWB.
5. Perform the System Check.
Telecopier 7032 / 7033 Service Manual
cord, and
cord, and
interface